NoSpray® Shields Protection System
NoSpray® Shields are designed to contain the spray of hazardous liquids in vessel engine rooms, a cause of dangerous fires and loss of life and property.
NoSpray® Shields are manufactured in multiple layers from a silicone rubber applied on a silica fibre fabric, specially formulated to withstand high temperatures and pressures, and an aluminum foil lining, which creates a corrosion resistant barrier for long lasting protection.
NoSpray® Shields are available in various widths which can be cut to size for use on flanges, valves, fittings, or any irregular shaped surface which can leak hazardous liquids. NoSpray® Shields encapsulate the protected surface and are easily installed using our drawstring system. Removable, reusable and extremely durable, NoSpray® Shields provide a consistent, clean look in vessel engine rooms.
- 4” Roll for typical flanges on a 25 mm (0.5”) to 50 mm (1”) pipe diameter
- 6” Roll for typical flanges on a 50 mm (1”) to 100 mm (2”) pipe diameter
- 12” Roll for typical flanges on a 100mm (2”) pipe diameter and up
Meets SOLAS Regulation II – 2/15.2.11
Installation Instructions
- Measure the outside diameter of the flange and cut the NoSpray Shield to a length of 130%.
- Cut a small hole about 1” (25mm) from each end of the shield on the pocket.
- Centre the shield on the flange and wrap snugly, overlapping the ends.
- Thread a lacing wire through each of the two cut holes and pull the lacing wire through the pockets.
- Draw together and fold under the cut edge of Shield for a neat finish.
- When pulled together snugly, secure with pliers and cut off excess wire.
